![]() I guess I can ziptie them back now that I'm done.Īnyway, once I found the main connector, I disconnected it from the power supply, and instead connected it to the motherboard ARGB header (one of the pins in the header supplies power, while another is the data pin that sends commands over the wire to the lights. This took me a few minutes, and I had to cut the zipties holding the many cables inside the PC cleanly in place unfortunately. So all I did was find the "ultimate connection point wire"-this is what connected to the actual power supply wire, and was the wire that all the other wires from the other lights eventually connected to. So.the lights have power, and they light up, and go into a default changing pattern.but they can't be controlled, because they're not connected to that motherboard ARGB header. And guess what? Instead of connecting it that way, Cyberpower connected it to the main PC power supply. Here's the crucial bit: that connector needs to be connected to the ARGB (or RGB, if it's not an ARGB fan light) header on the motherboard. Because you'll have probably have multiple fans but only one or two headers, these wires from the fans usually will combine with each other once, twice, or even three times, and all "funnel" eventually to one connector (the way many streams combine with each other and eventually wind up in one river). Your RGB-lit fans have wires coming out of them that allow you to control the lights (and obtain power, either 5V or 12V). Look for "Aura" or "ARGB" or "RGB" in the manual. If you don't know where they are on your motherboard, or how many your motherboard has, download your motherboard's user manual. ![]() The Z490-V has two of them: one for regular RGB lights, and another for "ARGB", or addressable RGB. These are little four-pin or three-pin connection points on the motherboard. Most motherboards have one or more "RGB" or "ARGB" headers. I wrote to Cyberpower tech support, and they ever so unhelpfully told me that all I could do was disconnect the lights if I wanted to turn them off. It had pretty coloured RGB fans, but I couldn't do anything with the lights to turn them off or change their pattern. This one: It has an ASUS Prime Z490-V motherboard. You need to find the "master wire" that all the RGB fans funnel to, disconnect it from the PC's power supply, and connect it instead to the RGB/ARGB header on your motherboard.Ībout two years ago, I bought a pretty bog-standard Cyberpower PC off Amazon. I'll give you the TLDR first: if you have a Cyberpower PC and your fan RGB lights are on and working, but you can't control them, then check your motherboard's RGB/ARGB header-I'll bet you there's no wire connected to it. I'm sure many of you old hands will go "oh, he should've known all this from the beginning", and you're probably right but I'm just writing this in the hopes it'll help some other poor schnook like me. Well, this only took me two years to solve.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |